Electrical Wire Threader, a tool, have come out, greatly reducing the difficulty of workers'threading work. Wire threader is a convenient tool, its appearance makes indoor decoration of the circuit decoration, especially the dark line decoration, has been greatly facilitated. In addition, the wire threader itself low cost, simple production, has become a necessary tool for circuit workers. Then, how do I use the wire threading machine?

Introduction of Electrical Wire Threader
The Electrical Wire Threader can also be called perforator and tube piercer. It is the best auxiliary tool for pulling the guide rope in the pipeline. Smooth and flexible surfaces can easily pass through narrow passages. The perforator is mainly composed of three parts: copper core, glass fiber reinforced layer and high-pressure low-density polyethylene protective layer. The threader was first used in wall traction, and later developed into the application of sewer cable, with time-saving, labor-saving, improve efficiency and other advantages.

Characteristics of Electrical Wire Threader
1. high tensile strength, strong bending capability, free shuttle in narrow pipes.
2. equipped with rustproof traction head.
3. strong anti-aging properties.
4. simple maintenance
5. equipped with mobile or portable scaffold for easy movement.

How does Electrical Wire Threader work?
When installing dark wire lines, people often insert wires into pre-buried pipes without threaders, and then slowly pass through them. In this process, because of the softness of the wires, the wires often get stuck in the center of the pipes, and the dilemma between them often occurs. After such a situation, workers will be wasted for a long time to make workers complain incessantly.
Fortunately, there is a Electrical Wire Threader this simple tool, using its wires, mesh lines, cable, video cable can be easily worn, very efficient. Because it is a dark line, so we must lay a good wire line before threading, the wire line here is made of pipeline laying, and we are going to do the next threading work in these pipelines. It should be emphasized here that special benders are used to bend the pipe at the bend of the pipe. Otherwise, it is difficult for the wire to pass through here.
By the time all the preparations have been completed, the threading can be used for thread drawing. First, the rope at one end of the threader is inserted into the junction pipe, and then the rope is pulled out at the other end of the junction pipe. In this process, to ensure that the rope in the entire junction pipe unobstructed, can not bend in the pipeline, in order to avoid the subsequent difficult to thread work.
The two ends of the wire to be threaded are cut about five centimeters apart, and one end of the wire is wound around a small coil at the end of the connector. If several wires need to be connected simultaneously in a junction tube, these wires can be wound together, fixed together with tape, and wound together in a small coil. Then, two people need to hold the two ends of the threader, one at one end tugging the rope head above the threader, the other will slowly rotate the small coil, the small coil wire slowly into the junction pipe, so that one end of the pull, a section of the feed. The wires will soon be worn out. If in this process, the wire is stuck, you need to tap the tube, until it is loose.